The two types of flares used on brake lines are ________
A) Ball flare and bubble flare B) SAE and double flare
C) Double flare and ISO D) SAE and DOT
C
You might also like to view...
A clutch disc is being installed. Technician A says that the damper assembly of the clutch disc normally faces the pressure plate. Technician B says that the disc splines should be lightly lubricated. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Answer the following statement(s) true (T) or false (F)
1. Most single-phase motors have fractional horsepower ratings. 2. The rotor of the resistance-start, induction-run motor is the same as that of a three-phase, squirrel-cage induction motor. 3. Universal motors operate at different speeds on dc and single-phase ac. 4. Stepping motors are devices that convert mechanical movement into electrical impulses. 5. When stepping motors are used as two-phase synchronous motors, they have the ability to virtually start, stop, or reverse direction of rotation instantly.
The depth of penetration of flare-formed groove welds is assumed to extend to ____.
A. the ends of the members B. the tangent points of the members C. the distance equal to the width of the members D. the closest flush surface of the members E. none of the above
What type of noise will be caused by a piston slap?
A. A sharp, metallic rapping noise that occurs with the engine idling. B. A hollow, bell-like noise that is most often occurring during cold engine warmup C. A light, rapping noise at speeds above 35 mph. D. A heavy thumping knock when the engine is first started