Define the following terms below:
(a) home-based work (HBW) trips
(b) home-based other (HBO) trips
(c) nonhome-based (NHB) trips
(d) production
(e) attraction
(f) origin
(g) destination
(a)Home-based Work (HBW) trip – a trip for which the purpose is to go from
home to work or from work to home.
(b) Home-based Other (HBO) trip – a trip for which the purpose is to go from
home to another location other than work (e.g., shopping, school, theater) or from
non-work locations to home.
(c) Non-Home Based (NHB) trip – a trip for which neither trip end is at home. A
trip falling into this category might be one that goes from work to shopping, or
school to work.
(d) Production – the ability of a zone to generate trip ends. For all non-home
based trips, productions are synonymous with origins.
(e) Attraction – the ability of a zone to generate trip ends. For non-home based
trips, attractions in a zone can be considered synonymous with trip destinations in
that zone.
(f) Origin – point at which a trip begins.
(g) Destination – point at which a trip ends.
You might also like to view...
Define flatness tolerance.
What will be an ideal response?
The table below shows the five data points, and corresponding predictions from the Peng-Robinson equation of state made using the binary interaction parameters k12=0.1 and k12=0.3. If your ONLY options were to use either k12=0.1 or k12=0.3, which would you pick? Give a quantitative rationale.
A pair of compounds, identified as 1 and 2, have the following properties:
You have five known VLE data points at 325 K. Your task is to generate the Pxy diagram describing all VLE mixtures of these compounds at 325 K, using phi-phi modeling and the Peng-Robinson equation.
All of the following are acceptable attribute identification approaches, except: (choose one)
(a) Employing small group discussions (b) Using the same attributes that competing entities use (c) Getting input from experts with relevant experience (d ) Surveying the stakeholders
When working in spaces with low clearance, __________ screwdrivers, which are screwdrivers with very short shanks, are often needed
A. hex-head B. long-handled C. offset D. stubby-type