A clutch will normally last in excess of 100,000 miles.
Answer the following statement true (T) or false (F)
True
You might also like to view...
A ____ type of motor shaft is found on very small shaded pole C-frame motors. This type of shaft design is limited to only very low torque requirement applications, because only the friction of the setscrew of the coupling device with the mechanical load is preventing the shaft from slipping.
a. flat b. key c. round d. threaded
Which of the following is true about solid-liquid equilibrium?Which of the following is true about solid-liquid equilibrium?
A. The liquidus curve will be a straight line (like the bubble-point curve) when you assume an ideal solution for the liquid phase. B. The melting point of all pure substances will decrease upon the addition of a second component. C. Separation using crystallization is never preferred over distillation. D. For solid-liquid equilibrium, the mixture fugacity coefficient of component i in the liquid phase must equal the mixture fugacity coefficient of component i in the solid phase. E. None of the above are true.
The diagnosis of a dual-clutch transaxle usually requires the use of ________.
A) A spring gauge B) Replacement shift cables C) A Snap-on scan tool D) A factory scan tool
When the refrigerant evaporates, it absorbs heat when it changes from liquid to gas. In which unit does this occur?
A) Thermal expansion valve or orifice tube B) Compressor C) Evaporator D) Condenser