Each code gives the ____ that changes a discontinuity to a defect.
A. procedure
B. correction
C. tolerance
D. flaw
Answer: C
You might also like to view...
As shown in the accompanying figure, backlash is the amount that a tooth space is greater than the engaging tooth on the pitch circles of two gears. Determine the average backlash of a gear with a working depth of 0.7764 inches using this formula: Average backlash = 0.030/P. Round to four decimal places.
What will be an ideal response?
List at least two other factors that shippers should take into consideration when choosing modes to ship products by.
A large manufacturer uses two factors to decide whether to use truck or rail for movement of its products to market: cost and total travel time. The manufacturer uses a utility formula that rates each mode. The formula is U = 6C + 14T, where C is cost ($/ton) and T is time (hrs). For a given shipment of goods, a trucking firm can deliver in 12 hrs and charges $30/ton, whereas a railroad charges $22/ton and can deliver in 16 hrs. What will be an ideal response?
Which of the following is not a type of valve used in the valve body?
A. Poppet valve B. Spool valve C. Check ball valve D. Stator valve
There are 15 numbers on a list, and the smallest number is changed from 12.9 to 1.29.
a. Is it possible to determine by how much the mean changes? If so, by how much does it change? b. Is it possible to determine the value of the mean after the change? If so, what is the value? c. Is it possible to determine by how much the median changes? If so, by how much does it change? d. Is it possible to determine by how much the standard deviation changes? If so, by how much does it change?