The two most widely produced oil crops are _____ and peanuts
a. wheat c. soybeans
b. corn d. cotton
C
Trades & Technology
You might also like to view...
Within a plant cell, there is/are _____ type(s) of plastid(s)
a. one c. three b. two d. four
Trades & Technology
?Arc strikes outside of the weld groove are _____________.
A. ?potential defects. B. ?easy to grind off if needed. C. ?usually small and are no problem. D. ?can be left if they are less than 1 in. (25 mm) from the groove.
Trades & Technology
Most engineering drawings include three views:
A. Top, front, and left-side B. Top, front, and bottom C. Front, right-side, and left-side D. Top, front, and right side
Trades & Technology
Which of these is NOT a danger when an automatic transmission is forced into a lower gear at a high speed?
A) Damage to the transmission B) Loss of engine breaking effect C) Loss of steering control
Trades & Technology