Technician A says that Volvo-Mack E3 fuel calibration codes are printed on the side of each injector. Technician B says that EUI fuel calibration codes are factory programmed at initial assembly and should not be changed during the life of the vehicle. Who is correct?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A nor B
Answer: A
Trades & Technology
You might also like to view...
Which of the following accomplishes the distribution of pressurized fluid to the appropriate reaction member?
A. Screen filter B. Check valve C. Valve body D. Oil pump
Trades & Technology
Once the _____ is complete, it is important to grind the weld to make sure that there is no cold roll or lack of fusion.? ?
A. root pass? B. GMAW process? C. FCAW process? D. hot pass?
Trades & Technology
Whenever possible, when changing a motor, the _________________________ should be obtained.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
What are the typical types of screws used on HVACR jobs?
What will be an ideal response?
Trades & Technology