A ____ plan is a drawing used to show the dimensions, framing members, methods of resisting gravity, and seismic and wind loads for a specific level of a structure.
A. roofing
B. load
C. framing
D. sheathing
Answer: C
Trades & Technology
You might also like to view...
____________________ tines do not remove a core
Fill in the blank(s) with correct word
Trades & Technology
A P0102 DTC is being discussed. Technician A says that a sensor circuit shorted-to-ground can be the cause. Technician B says that an open sensor voltage supply circuit could be the cause. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Trades & Technology
Find v? in the op amp circuit of Fig. 5.84.
 FIGURE 1.png)
Trades & Technology
Which of the following occupancies typically are required to have the hazardous (classified) locations documented by study?
A. Commercial Garages, Repair and Storage B. Aircraft Hangars C. Motor Fuel–Dispensing Facilities D. Petrochemical plants
Trades & Technology