Relay coils and the contacts they operate are not shown in the same place on a schematic diagram because:
A) Components are placed by their function in the circuit, not their actual physical location.
B) The coil and contacts are located in different places in the unit.
C) There is not enough room to draw them in the same place.
D) Schematic diagrams typically only show where to connect the power wiring.
A
You might also like to view...
Were Senator Joseph McCarthy's unsubstantiated and ruinous allegations of communist sympathies and activities against liberals, former and current government officials in the State Department and other government bureaucracies, and even members of the U.S. Army a reflection of his personal character or a manifestation of the larger American fears and anxieties about communism and social change in the late 1940s and early 1950s?
What will be an ideal response?
The top three quality grades for beef are:
A. USDA Supreme, Choice and Standard B. USDA Supreme, Choice and Good C. USDA Prime, Choice and Select
The caliper dust boot may need to be pried out with a(n) ________
A) C-clamp B) Screwdriver C) Air chisel D) Special tool
In the above figure, if the load decreases and causes the motor speed to increase, the voltage at the wiper arm of R11 ____________________ (increases, decreases), which causes the output of op amp 2 to become more ____________________ (negative, positive), which makes the output of the summing amp become more ____________________ (negative, positive), and causes the motor speed to ____________________ (increase, slow down).
Fill in the blank(s) with the appropriate word(s).