Describe the use of cross-reference zoning for sectioning applications.
What will be an ideal response?
When
necessary, locate sectional views on a sheet other than where the cutting
plane lines appear. The method for doing this is called cross-reference zoning
and is used to indicate the location of a section back to the viewing location
on a previous page. The sectional view is located on a different page and is
labeled with the sheet number and zone of the cross-reference cutting plane.
ASME Y14.3 does not recommend a specific zone and page identification
system. The cutting plane and sectional views should have a note correlating
each between sheets.
You might also like to view...
Andrew Jackson based his veto of the recharter bill for the Bank of the United States on
A. constitutional grounds exclusively. B. advice from Henry Clay and other close advisors. C. the Supreme Court's McCulloch v. Maryland decision. D. the fact that he found the bill harmful to the nation as well as unconstitutional. E. the belief that it was supported by the "necessary and proper" clause in the Constitution.
Review drawing number 522895A0A and then answer the question.
1. Are there any general notes shown on the drawing? 2. If so, what are they?
A(n) ____ joint is made by aligning the edges of two pieces of flat metal together so they are next to each other.
A. tee B. outside corner C. butt D. lap
Veitch diagrams can be constructed for two, three, or ____________________ variables.
Fill in the blank(s) with the appropriate word(s).