Use MATLAB to create a table that shows the relationship between the height of water above ground in the water tower and the water pressure in a pipe line located at the base of the water tower. The relationship is given by:



Create a table that shows the water pressure in lb/in^2 in a pipe located at the base

of the water tower as you vary the height of the water in increments of 10 ft. Also,

plot the water pressure (lb/in^2) versus the height of water in feet. What should the

water level in the water tower be to create 80 psi of water pressure in a pipe at the

base of the water tower?






We can see that in order to create a 80 psi water pressure in a pipeline at the base of the tower, the water level in the water tower should be approximately 190 ft.

Trades & Technology

You might also like to view...

If a nut or bolt is too tight to loosen with a wrench, ____.

A. use a cheater bar B. use a longer wrench C. use a smaller wrench D. cut the nut or bolt off

Trades & Technology

In adjusting a workpiece mounted on dead centers:

A) The footstock should remain unlocked to allow for expansion B) The workpiece should have no axial play, but be free to rotate C) The center adjustment should be tight enough to drive the part D) None of the above

Trades & Technology

A high-impedance digital multimeter should be used to test the oxygen sensor voltage.

Answer the following statement true (T) or false (F)

Trades & Technology

The EONV (engine off natural vacuum) test is being discussed. Technician A says that to perform it, the PCM is kept powered for up to 4 minutes after the ignition switch is turned off. Technician B says that the natural vacuum created in the fuel tank as the engine cools, is from about 3 inches to about 5 inches of water.  Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology