When checking a heater for a no-heat concern, both hoses are found to be too hot to hold. What could be the cause of no heat in the vehicle?
A) Air blend door fault
B) Loose hose clamps
C) Worn water pump belt
D) Bad thermostat
A) Air blend door fault
You might also like to view...
The perimeter around a rectangular ground source heat exchange bed 24 ft. long and 16 ft. wide is 384 ft.?
Answer the following statement true (T) or false (F)
Using the method of sections, determine the forces in the bars listed below the figure.
If the engine oil is not changed regularly, what is the most likely fault that can occur to an engine equipped with variable valve timing (VVT)?
A) The filter screens on the actuator control valve become clogged B) A no-start condition because the camshaft cannot rotate C) Low oil pressure diagnostic trouble code (DTC) D) Any of the above
If a resistor that is color-coded red-red-brown-silver is connected to a 15 V source, what is the maximum current that can flow?
A) 62 mA B) 68.2 mA C) 71.9 mA D) 75.8 mA