Which of the following is NOT a reason that most dimensions and tolerances are shown in decimal form:
A. Decimals are easier to work with
B. Decimals provide tighter tolerances than fractions could
C. Machine tools are graduated in decimal form
D. Measuring tools are in decimal form
Answer: B
You might also like to view...
The USDA states that any farm, wild crop harvesting, or handling operation that wants to sell an agricultural product as organically produced must adhere to the national organic standards
Indicate whether the statement is true or false
Technician A says that a steel piston should have a greater piston-to-caliper bore clearance than a phenolic piston because the steel piston will expand when the brake fluid temperature increases during normal braking. Technician B says that the phenolic piston should have the greater clearance. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
If an alternator has an "I" terminal it will be used to:
a. send power to the ignition circuit b. indicate to the ECM how much current the alternator is producing c. turn on the voltage regulator and excite the alternator d. turn on the rotor directly
Which of the following is a measure of combustion efficiency?
A) CO B) CO2 C) HC D) O2