Steam in a power plant is at 30 MPa and 400ºC in the boiler (steam generator). What mass of steam is contained in a 2-L volume?

A) 0.72 kg
B) 0.24 kg
C) 0.0104 kg
D) 0.0062 kg


A) 0.72 kg

Trades & Technology

You might also like to view...

Plot cross sections for each of the profiles listed in the field notes in Figure 12–15. Use a single ANSI D size sheet or two ANSI C size sheets for the layout. In each cross section, plot a 24? wide level road with 4? wide shoulders. The road elevation is 875?. The angle of repose for fill is 1 1/2:1 and 1:1 for cut. Label the road centerline and dimension the road and shoulder widths.

The road should slope 0.04 ft./ft. from the centerline to the edge of road. The shoulder slope is 0.06 ft./ft. Label the slopes on your drawing. Draw the cut and fill beginning at the outside edge of the road shoulder. Label the cut and fill with the appropriate symbol and values. Draw the existing grade as a dashed line in the areas of cut and fill. Use the Earth sectioning symbol in areas of undisturbed Earth. After drawing each cross section, determine the elevation at the intersection of the grade line and cut line. Use these elevations to calculate the earthwork involved between stations 5+00 and 7+00. Use the average end method illustrated in Figure 12–16 to calculate volumes of material in cubic yards and record the values by each cross section. What will be an ideal response?

Trades & Technology

The final pressure is nearest:

The frictionless piston shown in its initial position provides a pressure of 600 kPa in the cylinder. Energy is added until the temperature reaches 250°C.

A) 920 kPa
B) 980 kPa
C) 1020 kPa
D) 1220 kPa

Trades & Technology

Hydropower is the most widely used form of renewable energy for generating electricity

Indicate whether the statement is true or false.

Trades & Technology

Geologic erosion occurs at a faster rate than soil formation

Indicate whether the statement is true or false

Trades & Technology