Technician A says that adjusting front sheet metal is more restrictive on unibody than on BOF vehicles. Technician B says that an elongated hole may be used in conjunction with a cage-nut on the front fender to accommodate adjusting it. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technicians A and B
D. Neither Technician A nor B
C. Both Technicians A and B
You might also like to view...
Which of the following features would be required in an aluminum alloy, trunk type piston when used in a diesel engine application?
A. full floating wrist pin B. ring groove insert (Ni-Resist) C. chromed pin boss D. tin plating
A customer complains that the heater works sometimes, but sometimes only cold air comes out while driving. Technician A says that the water pump is defective. Technician B says that the cooling system could be low on coolant. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Give two alternate names for a parts list.
What will be an ideal response?
What is the engine block?
What will be an ideal response?