Stamping is generally done on hot metal than cold sheet metal.
Answer the following statement true (T) or false (F)
False
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. If a wire has to bent where it is installed into or onto a terminal, it should definitely be bent at the solder connection. 2. Mechanical stripping is used mostly for smaller gauges of wire with very thin insulative coatings. 3. Knives or strippers with square cutting edges and similar tools will nick, scrape, or gouge the wire. 4. Solder likes to flow toward the heat. 5. The best soldering method is to apply the iron to the item being soldered and then to add the solder.
What must happen before completing a delta connection?
What will be an ideal response?
Find the voltage across the capacitors in the circuit of Fig. 6.49 under dc conditions.
Where would a water regulating valve that is controlling head pressure be installed?
A. water circuit at inlet of condenser B. discharge line at outlet of compressor C. suction line D. liquid line close to the condenser