Typical parts made by a metal stamping process would be one of the following:
A. cell phone body cases
B. automotive parts
C. artificial joints for humans
D. all of the above
Answer: B
You might also like to view...
A contract document set consists of
A) construction drawings, specifications, and addenda. B) construction drawings. C) construction drawings, specifications, addenda, and contract modifications. D) construction drawings and specifications. E) none of the above.
Two technicians are discussing suspension bushings. Technician A says that replacing control arm bushings usually requires special tools. Technician B says using high-performance urethane bushings may cause excessive noise to be transferred to the passenger compartment. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Technician A says that many power windows and power door locks use a permanent-magnet motor with a built-in circuit breaker and is reversible. Technician B says that the control switches and relays direct the current through the motor(s). Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Sensors for the mixing valve control are located
A) outside the building and on the boiler. B) outside the building and on the supply line. C) outside the building, on the supply line, and on the boiler. D) on the supply line and on the boiler.