Overload is defined as operation of equipment in excess of normal, full-load rating, or of a conductor ____ that, when it persists for a sufficient length of time, would cause damage or dangerous overheating.
A. at 75% or of rated ampacity
B. in excess of rated ampacity
C. at 90% of rated ampacity
D. in excess calculated peak voltage
Answer: B
You might also like to view...
The acceptable industry standard for chipped brick usually is not more than _____ percent of the exposed face area of a brick wall or project.
A. 15 B. 10 C. 5 D. 1
The total resistance of a series circuit is equal to the ____________________ of resistances of all resistors in the circuit.
Fill in the blank(s) with the appropriate word(s).
A(n) ____________________ is a tube from 10 to 14 inches in length and about 2.5 inches in diameter
used to collect semen.
Fill in the blank(s) with the appropriate word(s).A ________ is all the framing below the rafter extensions that close in the roof system at the eaves
A) MDO B) Cornice C) Tributary area D) Drip line