What component cannot be flushed?

A) The condenser
B) The receiver-drier
C) The compressor
D) None of the above can be flushed


D) None of the above can be flushed

Trades & Technology

You might also like to view...

Technician A says many balance shafts are supported by needle bearings. Technician B says as the piston approaches TDC, its force pulls the engine up. Who is correct?

A. Technician A B. Technician B C. Both technicians D. Neither technician

Trades & Technology

Of all the principles of design, what is the easiest to measure if the other principles have been applied properly and comprehensively?

a. simplicity c. unity b. proportion d. balance

Trades & Technology

? Rafter Table for 4/12 Slope Length of Common Rafters Per Foot of Run 12.65" Length of Hip or Valley Rafters Per Foot of Run 17.44" Difference in Length of Jacks @ 16" on Centers 16 7/8" Difference in Length of Jacks @ 24" on Centers 25 5/16" Find the length of the tails of the jack rafters in the accompanying figure.

A. 8" B. 8 3/16" C. 8 7/16" D. 8 3/4"

Trades & Technology

To ensure your safety on the jobsite, you must stay alert, __________, and follow all safety guidelines.

A. attend safety meetings B. understand the hazards involved C. be first aid certified D. none of the above

Trades & Technology