Theoretically, when converting a coordinate tolerance zone with a positional tolerance zone, the diameter of the positional tolerance would equal the ____________________ of the coordinate tolerance zone.
Fill in the blank(s) with the appropriate word(s).
diagonal
You might also like to view...
Identify the following as dairy cattle, beef cattle, or swine breeds
a. dairy c. swine b. beef 18. Holstein 19. Angus 20. Hampshire 21. Duroc 22. Brown Swiss 23. Hereford 24. Brahman 25. Chester White 26. Jersey 27. Simmental
____ bias is used less often than voltage-divider bias because it requires two power supplies, one positive and one negative.
a. Emitter b. Collector c. Base d. AC
When doing a standard service entrance calculation, if a residence has four fixed appliances, a demand factor of __________% is applied to the total load of these appliances.
a. 50 b. 75 c. 80 d. 100
Dynamic memories such as the 2118 16k × 1 RAM have to multiplex the
A) control bus. B) data bus. C) address bus. D) All of the above are correct.