The purpose of the M30 code is to:

A. End the program, and reset
B. Start the spindle in a clockwise direction
C. Start the spindle in a counter-clockwise direction
D. Stop the spindle


Answer: A

Trades & Technology

You might also like to view...

Of the water plants take in through their roots, some is used for maintenance and growth, and some is

given off through the process of

a. expiration c. termination b. transpiration d. transfiguration

Trades & Technology

Identify this alternator component

A) Stator linkage B) Diode trio C) Alternator end housing D) Rectifier bridge

Trades & Technology

Natural gas floats on air. What does this tell us about its properties?

A) It has a higher specific gravity than air. B) It has a higher density than air. C) It has a lower volume than air. D) It has a lower specific gravity than air.

Trades & Technology

Determine if the circuit in Figure P5.70 is overdamped or underdamped for t < 0 and t > 0. Also find the capacitance that results in critical damping in both intervals. Assume VS = 15V, R = 200?, L = 20 mH, and C = 0.1?F.

Trades & Technology