Fully describe the weld, if one is required, at joint B.
Refer to Drawing Number 09022601 REV D.
3/8?? fillet weld, arrow side, all around with a flat weld face, weld per WP 940707-1
You might also like to view...
In the accompanying figure, x = 25 mm and y = 29 mm. Find Dia A.
What will be an ideal response?
On a typical plot of the refrigeration cycle, where does liquid refrigerant first begin forming in the condenser?
A) Where the condenser line (the top line) crosses the saturation curve from the superheated region B) At the end of the condenser line where it crosses the saturation curve into the subcooling region C) In the middle of the condenser line (the top line) D) At the start of the condenser line ( the top line), immediately after the compressor line
An increase in stick-out will result in:
A) No effect on current B) Increased current C) Increased voltage D) Reduced current E) Both A and D
In series heat-reclaim systems, what happens to the heat from the refrigerant in the compressor discharge line?
A) It is used to preheat the air for the store's HVACR system. B) It flows directly to the condenser. C) It is used to cool the air in the store's HVACR system. D) It flows to the heat-reclaim coil and condenser.