Technician A uses a dial indicator to check a hub flange for runout. Technician B says that excessive runout on a wheel hub flange would cause low frequency vibrations. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
C
Trades & Technology
You might also like to view...
Why are locking hubs also called freewheeling hubs?
What will be an ideal response?
Trades & Technology
Measurements taken by using the mass flow rate use __________ to determine the reading.
A. volume B. weight
Trades & Technology
The firing voltages of a four cylinder engine are as follows: #1: 8kV; #2: 27kV; #3: 4kV; and #4: 9kV. Which of the following is true?
A. Cylinder #2 may have an open plug wire. B. Cylinder #3 may have an open plug wire. C. Cylinder #2 may have an oil-fouled spark plug. D. Cylinder #4 may have an oil-fouled spark plug.
Trades & Technology
Why are steel reinforcing bars deformed?
What will be an ideal response?
Trades & Technology