Carry the answer to four decimal places. A bearing with an inside diameter of 1
inches is found to be 0.008 inch oversize for the armature shaft. What should the diameter of the bearing be to fit the shaft? Allow 0.002-inch clearance for lubrication.
Fill in the blank(s) with the appropriate word(s).
1.246
You might also like to view...
Technician A says that oxygen sensors can be tested using a test light or jumper wire. Technician B says conditions can occur that cause the oxygen sensor to be fooled and give a false lean or false rich signal to the PCM. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Slug-kill is made up of _____ percent methaldehyde dust?
A) ?15 B) ?20 C) ?5 D) ?50
Solar panels, thermal storage systems, and heat pumps may be used to
A) cool buildings during warm days. B) cool buildings during warm evenings. C) warm buildings during cool days. D) warm buildings during cool evenings.
G81 is a:
A) Canned cycle for drilling B) Canned cycle for tapping C) Canned cycle for single point threading D) Canned cycle for boring