Technician A says that a transmission with electronic shift controls senses engine load using a throttle position sensor in place of a throttle valve. Technician B says that a vehicle speed sensor is used in place of a governor. Who is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
C
You might also like to view...
In the brushless DC exciter, the commutator of a conventional direct-connected exciter is replaced with a threephase, bridge-type, ____.
a. solid-state rectifier b. controlled rectifier c. direct transformer d. small rectifier
If you accidentally spill any battery acid, the spill should be cleaned up immediately using a ____ solution.
a. water-and-baking-soda b. water-and-acid c. sulfuric acid d. oil-based
The wire sizes used in welded-wire fabric reinforcement are designated by _____.
a. AWG wire gauge b. cross-sectional area in hundredths of a square inch c. cross-sectional area in hundredths of a square centimeter d. diameter in thousandths of an inch
What is the function of the ABS solenoids?
A) They create pressure on the brake pedal B) They open and close hydraulic passageways C) They directly apply the brake pads D) To initiate master cylinder pressure