When testing a relay using an ohmmeter, which two terminals should be touched to measure the coil resistance?
A) 87 and 30
B) 87a and 87
C) 86 and 85
D) 86 and 87
C) 86 and 85
Trades & Technology
You might also like to view...
The ____________________ of a wire is measured by the diameter of the circle that the wire would make if it were loosely laid on a flat surface.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
The correct angle for the bevel at the end of a pipe is ____.
A. 27 1/2 degrees B. 32 degrees C. 35 1/2 degrees D. 37 1/2 degrees
Trades & Technology
Which of these statements is true regarding scrub radius?
A) It cannot be adjusted
B) It can be measured
C) Both A and B
D) Neither A nor B
Trades & Technology
Most shells keep a list of your recently used commands and allow you to recall a command without retyping it.
Answer the following statement true (T) or false (F)
Trades & Technology