The voltage from any line to a grounded neutral is the phase winding voltage and is usually called what?
What will be an ideal response?
The voltage from any line to a grounded neutral is the phase winding voltage and is usually called the phase voltage.
You might also like to view...
When working in cold weather, it is best to lubricate pivot points _____.
a. at startup b. at the end of the shift c. one hour after startup d. two hours after startup
All of the following statements are true EXCEPT:
A. emission of fuel vapors from the fuel tank can be controlled by sealing the fuel system from the atmosphere. B. on a hot day, gasoline in the tank contracts. C. air must be allowed to enter the fuel tank to take the place of fuel as it is consumed. D. the fuel tank can be vented by the gas cap or by a vent solenoid.
Answer the following statement(s) true (T) or false (F)Answer the following statement(s) true (T) or false (F)Answer the following statement(s) true (T) or false (F)Answer the following statement(s) true (T) or false (F)Answer the following statement(s) true (T) or false (F)Answer the following statement(s) true (T) or false (F)
1. Two-phase motors use the nameplate rating instead of the values shown in the table for full-load currents. 2. When the termination temperature rating is not listed or known, for circuits rated at 100 amperes or less, or for #14 AWG through #1 AWG conductors, the ampacity of the wire, regardless of the temperature rating, must be selected from the 60°C column 3. Starter sizes are rated by motor type, horsepower, and connected voltage. 4. All heater sizes are chosen from a chart supplied by the starter manufacturer 5. The size of the short-circuit protective device is determined by Section 430.62(A).
Sealants are used to fill in slight gaps in mating surfaces.
Answer the following statement true (T) or false (F)