What tool is used to check input shaft endplay?
A) Torque wrench
B) Feeler gauge
C) Calibrated pliers
D) Dial indicator and stand
D) Dial indicator and stand
You might also like to view...
Which historical approach to motivation is based on scientific management and thus takes
an economic incentive approach to motivation?
a. Traditional b. Human relations c. Human resources d. Content e. Process
For welding in the 1G-ROTATED, 2G, and 5G positions, the pipe axis can vary from the basic position by as
much as _____. a. 5 degrees b. 10 degrees c. 15 degrees d. 20 degrees
A major disadvantage of the Mask-Programmed ROM (MROM) is that it:
A) is time consuming to change the stored data when system requirements change. B) is very expensive to change the stored data when system requirements change. C) cannot be reprogrammed if the stored data needs to be changed. D) has an extremely short life expectancy and requires frequent replacement.
A ________ works on a single plane
A) Leveling vial B) Builder's level C) Total Station D) Transit-level