Most outboard CV joints are held onto the driveshaft by using a ________ at the end of the shaft
A) Snap ring B) Cap screw C) Circlip D) Any of these
A
You might also like to view...
During cold engine start or acceleration, the air-fuel mixture may be:
A. Leaner than normal B. Richer than normal C. Remain 14.7:1 D. None of the above
Evaporative emission control systems operate on low pressure measured in inches of water. One psi is equal to how many inches of water?
A) 10 B) 1 C) 18 D) 28
Which of the following is used to check for out-of-round?
A. vacuum enclosure B. holddown spring tool C. return spring tool D. drum brake micrometer
Use Data 12 sheet in text book.Mixed number Example: 2-1/3Put a dash between the whole number and the fraction.Simple Fraction Example: 2/3
Constant = 1.414e-e = c-c - (Total fit allowance)Round answer to the nearest 1/16 of an inch.The answer is in inches!If the pipe is 3" NO-Hub C.I.A = 15' 3"B = 14' 2"C = 10'Find e-e for "A."
Fill in the blank(s) with the appropriate word(s).