After a non-drive-wheel bearing has been properly adjusted, the wheel should have how much end play?
A) Zero B) 0.10 to 0.30 in. C) 1/16 to 3/32 in. D) 0.001 to 0.005 in.
D
You might also like to view...
Technician A says that if a turbocharger wheel has been rubbing against the housing, the turbocharger must be replaced. Technician B says that a bad turbocharger can cause engine oil consumption. Who is right?
A. Technician A B. ?Technician B C. ?Both A and B D. ?Neither A nor B
A transistor has values of IB = 80 ?A and ? = 190. Therefore, IC is
A) 80 ?A B) 15.2 mA C) 2.38 mA D) 15.2 ?A
What is the purpose of the hot reactivation air stream in a desiccant wheel dehumidifier?
A) To evaporate the water running over the wheel B) To dry out the saturated desiccant C) To heat the evaporator D) To cool the condenser
The placement of a flow sensor should be __________ pipeline diameters from a geometric obstruction.
A. 1 B. 2 C. 10 D. 20