Actual measurements for construction are taken from the _____.

a. primary control points
b. secondary control points
c. subsidiary control points
d. working control points


Answer: D

Trades & Technology

You might also like to view...

Technician A says that in a two-speed Ravigneaux gear train, one sun gear is driven whenever the turbine shaft turns. Technician B says that it will always be in neutral if there is no reaction member. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

What depth scale is usually used for most steel columns?

What will be an ideal response?

Trades & Technology

A port-type injection system squirts fuel where?

A) Into the cylinder B) Below the throttle plate C) Above the throttle plate D) In the intake port, near the intake valve

Trades & Technology

What is the lowest temperature a cooling tower can produce?

A) A few degrees above the incoming air temperature B) Down to a few degrees above absolute zero if applied correctly C) A few degrees above the incoming air wet-bulb temperature D) 32°F, the temperature where water freezes

Trades & Technology