The difference between the liquid and plastic limits of a soil is:
A) greater than the difference between the solid and liquid limits.
B) that one is applicable to natural soils the other to artificial growth media.
C) that one is a moisture variable while the other is a density variable.
D) the plasticity index.
E) none of the above
D
You might also like to view...
If the accumulator is sweating should it be insulated? Why or why not?
a. No because it would make rusting a greater problem. b. Yes because rusting will cause pin-hole leaks in the steel body. c. Yes because it will stop the sweating and prevent water damage. d. No because it would stop the transfer of heat needed to boil off the refrigerant.
If the transmission fluid temperature (TFT) sensor indicates cold automatic transmission fluid, what would the PCM do to the shifts?
A) Normal shifts but overdrive will be disabled B) Normal shifts and normal operation of the torque converter clutch C) Delayed shift points and torque converter clutch disabled D) Disable torque converter clutch; normal shift points
Which of the following is a disadvantage of a solid rear axle?
A) Reduced tire adhesion B) Side to side shock transference C) Increased proportion of unsprung weight D) All of these are disadvantages of a solid rear axle.
Technician A says that a power-assisted brake system reduces stopping distances compared to a nonpower-assisted brake system. Technician B says that the power-assisted brake system reduces the force that the driver must exert on the brake pedal. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician