How many millimeters are there in 6 inches?
What will be an ideal response?
152.4
You might also like to view...
The accompanying figure shows a broken combination bell and buzzer. Explain exactly what is broken and which part(s) will and will not work.
?Undercut shall not exceed the lesser of ______% of the base metal thickness or ____________.
A. ?10%, 1/32 in. (0.8 mm) B. ?5%, 1/16 in. (1.6 mm) C. ?8%, 3/64 in. (1.2 mm) D. ?3%, 1/64 in. (0.4 mm)
PROBLEM 3.47 Solve Prob. 3.46, assuming that both shafts are made of a brass with G = 5.6 × 106 psi and ?all = 8 ksi. PROBLEM 3.46 The design specifications for the gear-and-shaft system shown require that the same diameter be used for both shafts and that the angle through which pulley A will rotate when subjected to a 2-kip·in. torque TA while pulley D is held fixed will not exceed 7.5°. Determine the required diameter of the shafts if both shafts are made of a steel with G = 11.2 × 106 psi and ?all = 12 ksi.
A "floating" TTL input is an:
A) unused input that is tied to ground. B) unused input that is tied to Vcc through a 1-k? resistor. C) unused input that is tied to used inputs. D) unused input that is not connected.