When is a good time to clean the robot and what is a precaution to keep in mind while cleaning the robot?
What will be an ideal response?
A good time to clean the robots is when the power is off during the startup
inspection and the robot has a buildup of dust or grime. When cleaning the robot,
avoid using compressed air as this may drive foreign materials into the joints and
bearings of the robot.
You might also like to view...
What radius is required on the corners of the top plate on the skid?
Review drawing number 523808C0A and then answer the question.
When a spring pin fails to take grease and you know the zerk fitting to be functional, which of the following should you do first?
A. Replace the spring pin B. Remove the weight from the spring C. Replace the spring D. Remove and inspect the spring pin
A furnace that is composed of a heat exchanger compartment and a blower compartment is considered:
A) A radiant heat furnace. B) A gas-fired boiler furnace. C) A gas forced-warm-air furnace. D) An oil-fired boiler furnace.
What starter design technology allows for smaller, lighter starter motors?
A. AC induction starters. B. Reduction-gearing starters. C. Shaded pole starters. D. BLDC motors.