After installing a second processor and corresponding heatsink into a server, an administrator notices that the new processor is not showing up during POST. Which of the following could be the cause of this issue?
A. The power supply is not sufficient to power the server.
B. The voltage regulator module (VRM) was not installed.
C. The IRQ setting was not set.
D. The DMA setting was not set.
Answer: B. The voltage regulator module (VRM) was not installed.
You might also like to view...
The Current & Below cloning option samples the artwork ____.
A. by sampling the top two layers B. by sampling the appearance of the artwork as a composite from the current layer and all layers beneath it C. by sampling the top and bottom layers only D. by sampling from the targeted layer only
The ratio of the width of a display to the height of the display is the ________ ratio
Fill in the blank(s) with correct word
Which of the following units is used to measure frequency?
A. decibel B. volt C. hertz D. byte
Explain why over time, there is a trend toward fewer standards to support a specific technology
What will be an ideal response?