What input signal of the 74192/74193 up/down counter controls the Load function?
A) TCu B) MR C) Cpu D) PL
D
You might also like to view...
A(n) _____ is an objective interviewer who runs a focus group
a. interviewer b. mediator c. moderator d. questioner
Technician A says the multiplexer is used to a switch to allow the antenna and the rear heater grid to use the same circuits. Technician B says Wi-Fi wireless internet connection can be used to create a Hotspot in the vehicle. Who is correct?
A. Technician A only B. Technician B only C. Both Technician A and B D. Neither Technician A nor B
What does the instruction, MOV A, #00H do?
A) zeros out accumulator B) zeros out register C) increments register D) increments accumulator
For the balanced, three phase network shown below assume that all data is per unit on a 100 MVA base except for the transmission line reactance. Assume a 20 kV voltage base for the generator and motor, and a 138 kV voltage base for the transmission line.
a. If the system is initially operating unloaded with all voltages at 1.0 per unit, what is the magnitude of the fault current (in amps) if a balanced, three phase fault occurs on the terminal of the generator on the left. You should neglect the dc offset current. b. During the fault from part a, what is the per unit voltage magnitude on the terminal of the motor? c. Repeat part a, except now assume that the generator is supplying 100 MVA with a 0.8 lagging power factor and a terminal voltage of 1.0 per unit.