A weld shop supplies 25 shaft blanks, each 8” wide and 18” long. How many can be cut from a plate that is 35” wide and 65” long?
What will be an ideal response?
ANS: 12
Trades & Technology
You might also like to view...
?If the block does not have aligning pins for the timing cover, how can the cover be aligned?
What will be an ideal response?
Trades & Technology
What are flush plates used for?
a. providing decoration on door frames b. allowing the door to pivot c. strengthening corners of frames and doors d. all answers are correct
Trades & Technology
Electronically controlled valves, hydraulic pumps, and wet clutches are components found in a(n) _____.
A. Haldex clutch B. Torsen unit C. Quaife differential D. Control Trac II
Trades & Technology
Which of the following is NOT a type of full authority fuel management system used on light duty diesel engines?
A. CR. B. EUI. C. HEUI. D. PLN.
Trades & Technology