If the manometer measurement shown in the following figure occurs, a __________ gage pressure reading is made.
A. negative
B. positive
Answer: A
You might also like to view...
The emergence of the interwar “new woman” appeared to pose a direct challenge to what pre-existing traditional structure?
a. politics b. morality c. ethics d. culture
An engine is operating at 2,000 RPM while the vehicle is traveling down the highway. The oil pressure should be about ______
A) 50 PSI or higher B) 10-12 PSI C) 20 PSI or higher D) 3-7 PSI
Technician A says that the ECT and IAT sensors can be tested visually, as well as by using a digital multimeter or a scan tool. Technician B says that the ECT sensor is a high-authority sensor at engine start-up and is used for open-loop control, as well as idle speed. Who is right?
A) Both technicians A and B B) Technician B only C) Neither technician A nor B D) Technician A only
Rotor finish is measured in ________
A) Centimeters B) Millimeters C) Inches D) Microinches