Fault isolation diagrams and troubleshooting tables help the technician locate problems through the process of:

A) Interpolation. B) Elimination. C) Sublimation. D) Extrapolation.


B

Trades & Technology

You might also like to view...

For a given number of poles, which of the following determines the speed of an AC motor?

a. Voltage b. Current c. Frequency d. Frame size

Trades & Technology

Computers use ________ for the temporary storage of programs and data

Fill in the blank(s) with correct word

Trades & Technology

If the application requires a coil design to operate below 32°F, there must be provision for ____.

A. flooding the evaporator B. adding refrigerant C. defrost D. suction pressure control

Trades & Technology

Steel shafts, 1.4 inches in diameter, are turned on an automatic machine. One finishing operation is required for an 11.5-inch length of cut. The tool feed is 0.023 inch per revolution using a cutting speed of 200 feet per minute. Using the formulas in the accompanying figure, determine the number of hours of cutting time required for 1500 shafts. Round the answer to the nearest hour.

What will be an ideal response?

Trades & Technology