Welded wire mesh shall be measured in plan area with an additional ____% included for overlaps.

A. 5
B. 10
C. 15
D. 20


Answer: B

Trades & Technology

You might also like to view...

A snapshot of an ad hoc network is shown in Figure 13.19.



Describe briefly the process taken to do the following:
(a) You need to create a route from the source node 6 to the destination node 23 using the DSR algorithm.
(b) Repeat part (a) using TORA routing.
(c) What changes would you make in part (a) if you use the AODV protocol?

Trades & Technology

This machine tool is commonly used to machine drilled holes and is also used for reaming, boring, countersinking, counterboring, and tapping.

a. drilling machine b. grinding machine c. lathe d. milling machine

Trades & Technology

Animals raised in disease-free environments cost less and pose less risk.

Answer the following statement true (T) or false (F)

Trades & Technology

Requirements for recovery/recycling/recharging equipment for R-1234yf refrigerant are set by SAE standard:

A) J1990 B) J2788 C) J2843 D) J2209

Trades & Technology