When soldering, the technician should heat the solder with the torch to allow it to melt.
Answer the following statement true (T) or false (F)
False
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The key to the speed with which binary information can be processed is that there are only three states, each of which is distinctly different. 2. Words can be made up of 32 bits, 16 bits, or 8 bits. 3. For fixed I/O controllers, all of the I/O are in slot 1. 4. MicroLogix processors have the same program files as the SLC 500 and three additional files. 5. When a computer program is first developed and edited, it is done in the program mode or the on-line mode.
Another word for a plumb bob is a _____
A) hammer B) plummet C) chisel D) rip saw
Technician A says that the best method of locating high resistances in a cranking circuit is by using voltage drop testing. Technician B says that using an ohmmeter can locate high resistance starter cable. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
A(n) ____ is an electronic circuit that has been fabricated with extremely small components as an inseparable assembly known as a(n) ____.
A. amplifier; input signal B. integrated circuit; capacitor C. printed circuit board; chip D. integrated circuit; chip E. none of the above