The depth of infeed or downfeed per pass in truing should be no more than:

A) .010 in. B) .001 in. C) .00001 in. D) .0001 in.


B

Trades & Technology

You might also like to view...

Which materials, used for casting, typically harden by a chemical reaction to complete the polymerization for thermoplastics or the cross-linking for thermosets?   

A. ?plastisols  B. ?hot-melt plastics C. ?dissolved plastics  D. ?short-chain polymers

Trades & Technology

If there are more turns of wire on the primary winding than on the secondary winding, the output voltage will be ____________________ than the input voltage

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

What is the best thing to do before evacuating a refrigeration system?

a. Replace the oil in the vacuum pump to make sure it will pull a good vacuum. b. Open the suction and close the discharge service valves to the refrigeration system. c. Pull a vacuum on the gauge and pump connections to make sure they are not leaking.

Trades & Technology

Use node voltage analysis to find the voltages V1 and V2 for the circuit of Figure P3.1.

Trades & Technology