How is size tolerances identified by the International Organization for Standardization (ISO) standard ISO 2768, General Tolerances specified on a drawing?
What will be an ideal response?
A general note that states the ISO 2768 class for general tolerances, such as ISO 2768-m, is placed on the drawing.
You might also like to view...
Soft metal gaskets are used for _____ pipelines.
a. water b. caustic chemical c. steam d. oil and gas
When the HPI-TP timing chamber has the most amount of fuel charged to it, which of the following should be true?
A. the least amount of fuel is injected B. the most amount of fuel is injected C. injection timing is at its most advanced D. injection timing is at its most retarded
This is a section that does not go completely through the structure, and is used to show construction materials that are not seen in other sections:
A. detail section B. full section C. longitudinal section D. partial section E. traverse section
The fan and limit switch in the gas furnace control ________
A) the temperature at which the fan turns on and the temperature at which the air conditioner turns off B) the temperature at which the fan turns on and the temperature at which the gas is ignited C) the temperature at which the fan turns on and the maximum temperature the furnace can reach before power to the gas valve is turned off