How far below the finished surface should snow-melting and anti-icing systems be installed?

a. 1/4" to 1/2"
b. 1-1/2" to 2"
c. 2" to 3"
d. 3" to 4"


b. 1-1/2" to 2"

Trades & Technology

You might also like to view...

Technician A says that an EHI with a Piezo actuator is capable of breaking up a single injection cycle into up to 7 separate pulses. Technician B says that during a CR EHI multipulse injection cycle, the pressure rises through each successive pulse.  Who is correct? 

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

The total approximate gravity load on a floor in a typical wood frame residential building is

A) 10 psf. B) 30 psf. C) 50 psf. D) 5 psf. E) none of the above.

Trades & Technology

An engine produces 375 lb-ft. of torque. How much torque is delivered to the drive wheels if the transmission ratio is 3.37:1 and the drive axle is 3.87:1?

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

The voltage drop on each branch of a parallel circuit is ________

A) Reduced by the resistance of loads in each branch B) Equal C) Increased by the resistance of loads in each branch D) None of these

Trades & Technology