Which elements and signals of a control system do not exist in an open-loop configuration?
A. comparator
B. error signal
C. measurement device
D. feedback signal
E. all of the above
Answer: E
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. Multiple Class 2 or Class 3 power supplies can be wired in parallel with each other. 2. Coaxial cable connecting a video camera to a monitor is an example of integral wiring. 3. Class 1 circuits typically operate from greater voltage and current levels than those of Class 2 or 3 circuits. 4. Class 1 circuits, that are not functionally associated, must be separated from power conductors by a solid and firmly fixed barrier. 5. Insulation requirements for Class 1 conductors 18 and 16 AWG must be suitable for 600 V.
Connecting a 120V heating cable to a 240V circuit will _____.
a. melt the cable b. produce only 25% of the rated cable wattage c. cause the system to operate within acceptable standards, but at less than full efficiency d. enable the system to operate most efficientl
Answer the following statement(s) true (T) or false (F)
1. In high school most learning took place inside the classroom whereas in college most of the learning will take place outside the classroom. 2. It is not a good idea to take notes on loose papers because you may displace or lose them. 3. A good way to learn something is to explain ideas and concepts in your own words to others in a group. 4. It is a good idea to attend class regularly, because your professor may offer additional explanations and discussion of some material in class that may not be well presented in your textbook. 5. It is a good idea to read the material that your professor is planning to cover in class ahead of time. It is also important to go over the material that was discussed in class again later the same day after the lecture was given.
A chain line ____.
A. must have its length and location dimensioned B. is used when it is more realistic to apply a datum feature symbol to a portion of a surface rather than the entire surface C. is used when a long part has a related feature located in one or more concentrated places D. all of the above E. none of the above