What tool should be used to smooth the end of the pipe after it has been cut?
A. threader
B. tile
C. sandpaper
D. reamer
Answer: D
Trades & Technology
You might also like to view...
In the accompanying figure, because control relay CR is used as a(n) ____________________, it must be permitted to remain energized when either or both of the motor starters are not energized.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
Which of the following is the more accurate way of expressing torque?
A. force B. work C. linear effort D. turning effort
Trades & Technology
A plant compensates for cooler temperatures by using more energy derived from carbohydrates,
resulting in higher ____ levels.
a. photosynthesis c. food production b. respiration d. light energy
Trades & Technology
If a low-pass RL filter's cutoff frequency is 20 kHz, its bandwidth is ________
A) 0 Hz B) 40 kHz C) 20 kHz D) unknown
Trades & Technology