A diameter dimension and tolerance applies only to the end of the feature where is is shown.
Answer the following statement true (T) or false (F)
False
Trades & Technology
You might also like to view...
In temporary fiberglass pipe runs, the method often used for joining the pipe is the _____ method.
a. Redi-Thread b. butt and strap c. bell-and-spigot d. EUE threaded
Trades & Technology
A parallel heat reclaim system primarily recovers:
A) Sensible heat from the refrigerant. B) Latent heat from the refrigerant. C) Both sensible and latent heat from the refrigerant.
Trades & Technology
It is possible for a refrigerant to absorb heat at a low temperature and reject heat at a higher temperature.
Answer the following statement true (T) or false (F)
Trades & Technology
The fluid flow shown in the illustration occurs when the brakes are:
A. being applied. B. being released. C. at rest (completely off). D. none of the above.
Trades & Technology