Which one of the following describes the left to right order of a feature control frame?
A. tolerance zone descriptor, geometric characteristic, geometric characteristic tolerance, primary datum reference
B. geometric characteristic tolerance, geometric characteristic, tolerance zone descriptor, datum reference
C. geometric characteristic symbol, tolerance zone descriptor, geometric characteristic tolerance, datum reference
D. geometric characteristic symbol, material condition symbol, geometric characteristic tolerance, tolerance zone descriptor, multiple datum reference
E. none of the above
Answer: C
You might also like to view...
Gas caps are non-venting and usually have some type of ____________________ relief
Fill in the blank(s) with the appropriate word(s).
Convert the following to SI units, using the correct significant figures.
 FIGURE 1.png)
Which of the following is a federal governmental agency that creates and oversees the laws and governing possession of exotic animals?
a. CITES b. APHIS c. CEWAP d. EPA-MAIA
Determine the power from the visible, UV, and IR components of sunlight striking the surface of a PV panel with a total irradiance of 500 W/m2 if the panel is 0.5 m square. What is the energy in kWh if the specified irradiance is on the panel for 10 hours?
What will be an ideal response?