Electrical symbols should be written with _____.
A. squares 3" (75 mm) in diameter
B. squares 6" (150 mm) in diameter
C. circles 3" (75 mm) in diameter
D. circles 6" (150 mm) in diameter
Answer: D
You might also like to view...
What is the generally recommended method of filling a new secondary fuel filter following a filter service?
A. charge air tanks with shop air B. install an auxiliary electric pump into the fuel sub-system C. hand or electric pump prime after installation D. fill with fuel prior to installation onto the filter mounting pad
What are some of the drawbacks of the generator when compared to the alternator?
What will be an ideal response?
Technician A says that some brake pads have tapered edges to prevent vibration. Technician B says that pad wear indicators are required by law on all new vehicles. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
If insulation or roofing materials contain chemicals that are hazardous, the manufacturer must provide a
_____. a. chemical ingredients list b. safety data sheet c. hazard warning label d. materials safety disclaimer