When using a tap, it is generally acceptable to drill the hole that will allow approximately ____ percent of the full thread to be used.

A. 50
B. 75
C. 80
D. 100


Answer: B

Trades & Technology

You might also like to view...

Why was the Clarence Thomas-Anita Hill affair so polarizing? What did the radically differing perspectives on the Thomas nomination say about views of gender, race, and ideology?

What will be an ideal response?

Trades & Technology

Double Cardan joints can function at a maximum angle of ________

A) 10 degrees B) 0 degrees C) 2 degrees D) None of these is correct

Trades & Technology

____________________ is the rate of change of velocity with time.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

In order to reduce the amount of refrigerant a system will use, and to eliminate refrigerant flow to display cases, some manufacturers are turning to the usage of a(n) ____________________.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology