If the brake pedal does not return to the released position or is sticking or binding, what is the most likely cause?
A. Rear brake out of adjustment
B. Dry or corroded cable
C. Excessive cable slack
D. None of the above
Answer: B
You might also like to view...
A two-lane highway bridge, supported on two deck trusses that span 64 ft, consists of an 8-in. reinforced concrete slab supported on four steel stringers. The slab is protected by a 2-in. wearing surface of asphalt. The 16-ft-long stringers frame into the floor beams, which in turn transfer the live and dead loads to the panel points of each truss. The truss, bolted to the left abutment at point A, may be treated as pin supported. The right end of the truss rests on an elastomeric pad at G. The elastomeric pad, which permits only horizontal displacement of the joint, can be treated as a roller. The loads shown represent the total dead and live loads. The 18-kip load is an additional live load that represents a heavy wheel load. Determine the force in the lower chord between panel points I
and J, the force in member JB, and the reaction applied to the abutment at support A.
What is Manual J?
What will be an ideal response?
If the output of a proportional mode control system oscillates, the system gain is set too ____________________ (low, high), its proportional band is ____________________ (narrow, wide), and the response time is ____________________ (slow, fast).
Fill in the blank(s) with the appropriate word(s).
The lowest common denominator when adding the fractions 1/20 + 1/5 + 1/15 is 30.
Answer the following statement true (T) or false (F)